Application and Analysis of a New Corrugated Tube Heat Exchanger to the Heating System in Thermal Power Plant 新型波节管换热器在热电厂供热系统的应用与分析
Numerical Calculation of Intensified Heat Transfer Law of Air Externally Sweeping Across Corrugated Tube Bundles 空气外掠波纹管束强化传热规律数值计算
The heat transfer and flow resistance performance of corrugated tube heat exchanger were examined by oil, water, and steam. 采用油、水、水蒸气对波纹管换热器的传热和流动阻力性能进行了试验研究。
Numerical Calculation on Flow and Heat Transfer Rule in Corrugated Tube 波纹管内流动与传热规律的数值计算
Measurement and Analysis on the Attrition Loss of Prestress Wire of Plastic Corrugated Tube 塑料波纹管预应力摩阻损失测试与分析
Experimental investigation shows that the heat resistance of fouling in corrugated tube is0. 实验结果显示轧槽管的污垢热阻约为光滑管的0。
Study on Compression Joining Technology for Corrugated Tube Supporting Extended Diameter Conductor 波纹管支撑型扩径导线压接工艺的研究
Investigation on falling film flow and heat transfer characteristics inside corrugated tube 波纹管管内降膜流动与传热特性的研究
Experimental Study on Heat Transfer and Fouling Characteristics of Spirally Corrugated Tube 螺旋槽管传热特性与污垢特性的实验研究
High temperature superconducting contiguous manifold multiplexers Study on Compression Joining Technology for Corrugated Tube Supporting Extended Diameter Conductor 邻接型分支线式高温超导频分器技术研究波纹管支撑型扩径导线压接工艺的研究
Study on heat transfer and pressure drop performance of corrugated tube heat exchanger 厚壁波纹管换热器传热与阻力性能研究
Experimental Study of Heat Transfer Intensification for Heat Exchangers of "W" Type Spirally Corrugated Tube W形螺旋槽管管壳式换热器强化传热研究关于螺纹烟管的传热计算
The Research of Sealing Technology for Minitype Corrugated Tube Valve 小型波纹管阀门密封技术研究
Spirally corrugated tube can evidently increase in-tube and out-tube heat transfer coefficient with and without phase-change heat transfer. 螺旋槽管在有相变和无相变的传热中能显著地提高管内外的传热系数,通常起到双边强化传热作用。
In hydrogen system, the sealing properties and reliabilities of valves have higher requirement than other valves. It is important to research sealing technology for minitype corrugated tube valve in some special conditions. 氢系统用阀门的密封性和可靠性较一般阀门的要求更高,因此对特殊使用条件下的波纹管阀门的密封技术进行研究意义重大。
Further, the effects of different parameters on the stiffness were analyzed, and the calculation model for the stiffness of corrugated tube was proposed. 基于本文提出的波纹管刚度计算模型及波纹管的等刚度折算方法,本文对波纹管换热器管板强度的计算与设计进行了分析。
Research of Enhancing Heat Transfer and Application in Exchanger about New Pattern Stainless Steel Corrugated Tube 不锈钢波纹管强化传热机理分析及在换热器中的应用
Research and application of spirally corrugated tube 螺旋槽纹管研究及应用
The correctness of using periodic unit duct model to simulate the shell-side flow and heat transfer is confirmed for the first time, when using the corrugated tube. 本文首次验证了纵流壳程换热器选用波纹管作为换热元件采用单元流道模型对壳程进行数值模拟的正确性,同时验证了数值模拟结果的正确性。
Development and Application of Paraformaldehyde Waste Heat Boiler and Methanol Mixed Gas Heater of Transversally Corrugated Tube 横纹管甲醛废热锅炉及甲醇混合气加热器的开发与应用
Research, Development and Application of Corrugated Tube Exchangers 波节管换热器的研制开发与应用
Corrugated tube heat exchangers have been widely applied in industry recently due to their high heat transfer coefficient. 自波纹管换热器出现以来,就以其传热系数高,并具有除垢、防垢的特点而在工业生产中得到广泛地应用。
An Optimal Orthogonal Design of the Corrugated Tube Used in the Energy Absorbing of Automobiles 波纹管在汽车碰撞吸能中的正交优化设计
According to applied environment and function of minitype corrugated tube valve, the major structure materials in valve are selected, and the proper sealing structures are confirmed. Then the properties of corrugated tube for outside sealing are calculated and examined. 本文根据小型波纹管阀门的使用环境和功能要求,确定了阀门的主要结构材料,设计了阀门的内、外密封结构。
A comparison and an analysis are made of the characteristics and situations of use of plate, corrugated tube and super conductive heat pipe exchangers. 对板式换热器、波纹管换热器和超导热管换热器的特点及使用场合进行了分析、对比。
The mechanism of heat transfer enhancement of transversely corrugated tube was discussed. 文内还讨论分析了横纹管的传热强化机理。
In order to study the axial stiffness of the corrugated heat exchange tubes, two double-pipe heat exchangers respectively using corrugated tube and smooth tube were designed and the axial stresses at the outer tubes under the thermal loadings were evaluated both numerically and experimentally. 为研究波纹换热管的轴向刚度,本文设计了波纹套管换热器和直管套管换热器并以温差载荷作用下套管中的轴向应力为考察指标。
On the experience, we try the internal pressure blasting and external pressure squirm in smooth tube and corrugated tubes with different specifications, to verify the strength of corrugated tube is better than smooth tubes. 在试验方面,分别对光管和不同规格的波节管进行内压爆破和外压失稳试验,验证波节管在强度方面优于光管。
Currently, the technology of extended surface to enhance the condensation heat transfer process is widely used, for instance, the finned tube, corrugated tube, and spiral tube. 通过设置扩展表面来强化冷凝传热的方法和技术目前已经得到了较为广泛的应用,如翅片管、螺旋管、波节管等。